Power Puller Pulling
 |
| GM CHRYSLER POWER STEERING ALTERNATOR PULLY PULLER INSTALLER PULLING AUTO TOOL | |
 |
$49.99 Time Remaining: 3d 20h 48m Buy It Now for only: $49.99 |
| American Gage EZ Puller Portable 1 Ton Power Pull | |
 |
$35.56 Time Remaining: 1d 9h 31m Buy It Now for only: $35.56 |
| Maasdam 8112 Power Pull 2 ton Max Hoist Cable Extention 12 | |
 |
$13.49 Time Remaining: 7d 12h 16m Buy It Now for only: $13.49 |
| Maasdam 8106 Power Pull 2 ton Max Hoist Cable Extention 6 | |
 |
$13.49 Time Remaining: 7d 12h 16m Buy It Now for only: $13.49 |
| Mountain 4 Ton Power Pull | |
 |
$50.58 Time Remaining: 6h 51m Buy It Now for only: $50.58 |
| Maasdam 144S 6 Power Puller 1 Ton Pull Capacity Hoist | |
 |
$39.99 Time Remaining: 7d 10h 39m Buy It Now for only: $39.99 |
| American Power Pull AME18600 Winch Puller 2 Ton 6 Lift with Double Ratchet Dr | |
 |
$53.95 Time Remaining: 1d 15h 13m Buy It Now for only: $53.95 |
| Maasdam 144C 6 Power Puller 2 Ton Pull Capacity Hoist | |
 |
$49.99 Time Remaining: 7d 10h 39m Buy It Now for only: $49.99 |
| American Cable Winch Puller Power Pull model 18200 +Box | |
 |
$34.99 Time Remaining: 28d 7h 38m Buy It Now for only: $34.99 |
| ATD Tools 2 Ton Power Puller ATD 7495 Pulling Tool | |
 |
$7.99 Time Remaining: 21d 14h 50m Buy It Now for only: $7.99 |
Power Puller Pulling
I need help with a power steering pump pulley on my 93 Ford Taurus 3.0 V6?
I had to replace the power steering pump on my car and I got the pulley off with no problem with the special pulley puller tool and then I put the new pump on and I got the pulley on and all I have left is about a quarter of an inch left to put on but every bolt I use with the tool to put the pulley back on with ends of pulling back out of the shaft and the bottom of the bolt is smooth it tearing the threads off. What can I do to stop this and what is causing this? PLEASE HELP!!!!!
What's causing the problem is you are using the wrong size bolt or didn't have the right one screwed in far enough and have possibly damaged the threads to the point that no bolt will work. The problem with KIA's answer is that there is not a bolt that holds the pulley on, it is a press fit, as I'm sure you know. You are gonna have to find the right size thread tap and straighten the threads and then use the right size bolt to finish the job. I'm almost positive that pump uses a 3/8-16 UNC thread. Also check the depth of the threaded hole in the pump shaft and get one long enough to reach to the bottom
Lego power puller pulling 58KG-126.8Lbs video PROOF!