Gear Pulley Flywheel
 |
| 14 PC GEAR PULLEY FLYWHEEL PULLER BEARING SEPARATOR 1 | |
 |
$31.89 (1 Bid) Time Remaining: 1d 10h 37m |
| 14PC GEAR BEARING SEPERATOR PULLER SPLITER PULLS GEARS PULLEYS FLYWHEELS | |
 |
$31.99 Time Remaining: 10d 9h 1m Buy It Now for only: $31.99 |
| GEAR PULLEY FLYWHEEL PULLER BEARING SEPARATOR TOOLS | |
 |
$32.99 Time Remaining: 6d 7h 29m |
Gear Pulley Flywheel
What will my CRX probably dyno at?
its my project i just finished, alot of paychecks and overtime for this one. its basically just a crx si its got a b16A swap, ys1 cable transmission with factory limited slip,hasport shift linkage,exedy clutch/pressure plate,9 lb flywheel,boomslang obd-1 conversion harness,pr3 obd-1 ecu,spoon vc-3e vtec controller,70mm throttle body,blox manifold,stage 3 blox tuner series cams/blox cam gears,blox dual valve springs/Ti retainers,Rage tri-y header,Tanabe concept-g cat back,car is sleeved by darton( $800 bucks :.( , benen fuel rail, Eagle connecting rods 5.290 length, supertech 86mm pistons, knife edged crank with unorthodox pulley, ima use 92 octane, on thursday i have an appointment with Courtney green for the dyno, but im sort off on the down side because im afraid i wont hit atleast 200 mark.
well you should atleast go and see how much your work has produced, if it doesnt... a project car is never finished, you always buy better parts
Modified Mazda RX8 - launch & rev